亚洲色图10p,xxx.,欧美日韩国产激情一区二区三区,久久久久人妻精品一区二区三区

High quality hydraulic equipment manufacturers!
TELL:+8613184968882

tailplate hydraulic cylinder Sold to Tanzania

Release time:2023-11-21 09:56:03 Hits: Current position: Home > News

This article mainly introduces:

Tanzania hydraulic cylinder,tailplate hydraulic cylinder manufacturer,tailplate hydraulic cylinder

Tanzania tailplate hydraulic cylinder

(Tanzania tailplate hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory)

tailplate hydraulic cylinder are widely used in Tanzania,because of high work efficiency,excellent fatigue and impact resistance,no need for deceleration device.So our company has designed tailplate hydraulic cylinder for customers from Tanzania.

Introduction to tailplate hydraulic cylinder:

The tailplate hydraulic cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the tailplate hydraulic cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the tailplate hydraulic cylinder wall due to the stiffness and the weight of the parts, causing scars.

When the hydraulic oil is not pumped into the tailplate hydraulic cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the tailplate hydraulic cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

Because of the slightly complex structure of the buffer tailplate hydraulic cylinder, sometimes there will be problems, such as when the tailplate hydraulic cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

Repair method of small range wear of oil tailplate hydraulic cylinder: 1. Use oxygen-acetylene flame to bake the scratched part (master the temperature, avoid surface annealing), bake the oil on the metal surface all the year round until no sparks splash; 2. The scratched part is treated with an Angle grinder, the grinding depth is more than 1 mm, and the groove is polished along the guide rail, preferably a dovetail groove. Scratch both ends of the drilling deeper, change the force situation; 3. Clean the surface with absorbent cotton dipped in acetone or anhydrous ethanol.

Answers to some questions about tailplate hydraulic cylinder:

What is the cause of the sound of the excavator arm cylinder?
Hydraulic excavator cylinder includes boom cylinder, bucket rod cylinder and bucket cylinder, four cylinders. The sound of boom cylinder may be the wear of hydraulic cylinder block bushing, piston rod bushing and shaft pin. The main reason: poor lubrication, followed by improper clearance in the assembly process. Countermeasures: (1) Strictly lubricate each shaft pin at least once every 8 hours when the excavator is initially used for 100 hours and under harsh conditions; In other working conditions, lubricate each pin at least once every 50 hours. (2) If the lubricating oil passage is found to be blocked, it must be stopped for rectification. (3) Require assembly, replacement of all parts of the shaft pin, bushing strictly comply with the assembly testing standards and operating procedures.

What is a differential cylinder?
The differential cylinder is by connecting the return oil of the rod cavity through the pipeline, allowing them to flow into the rodless cavity, thereby speeding up the extension speed of the piston rod. In fact, the cylinder is still the cylinder, but the oil circuit is related to the connection. The oil connection mode in which both chambers of a single rod hydraulic cylinder are fed hydraulic oil is called differential connection.

Back to list Recommended article

Leave a message if you have any questions.

Send
Email

Email:hsslrubbertech@gmail.com7x24 hours

Glad to receive your consultation!:

Service
Tel

+8613184968882
7x24hours service

Add
Wechat

Add Wechat
TOP
中文字幕免费一区二区三区四区五区在线| 91无码大神| 扒开美女骚逼操| 一本三道a无限码一区v| 操日本不卡| 日韩国产AV一区二区三区四区| 中文字母av| 黑人巨屌肏屄视频| 久久精品国产中国| 日本麻豆喷水视频| 国产AV自拍一二三区| 逼痒了一区二区视频| 不卡一五日有码韩在线| 中文字幕大鸡巴不卡| 国产亚洲一区二区福利视频| 欧美内射逼逼| 操女在线播放| 五月丁香草逼视频| 日本精品热视频网站| 在线中文一区二区二区三区四区| 老太婆熟女pp一区二区| 一级二级三级AV影片| 啊啊啊我要视频| 操老阿姨老逼的逼| 国内极品一线天在线观看| 日韩一二三四精彩视频| 日韩老熟女自慰播放| 又长又出理论中文字幕| 怡红院视屏网址| 丝袜 制服 人妻 日韩一区| 日bav在线观看| 插出水视频国产| 亚迪第一页av| 久久青青草原国产精品乐播| 被大鸡巴操出白浆在线观看| 黑人大鸡巴大奶子| 日韩激情性爰图另类图片| 后入白嫩在线| 激情综合视频网韩国| 广元市| 文学激情校园激情av在线|